Some say that a service should be done every 2-3 years as the manufacturer suggests. There are a few methods of thought to the frequency of service. However, ultimately a complete overhaul will be required. The accuracy may be compensated by performing a couple of regulations (see above) over the course of a few years. Although this too is a simple procedure, it does require a little more time to correct as each position needs to be monitored and adjusted.Ī mechanical wristwatch is comprised of small gears, miniature screws and paper-thin springs - as with any mechanical instruments that have constantly moving parts, a mechanical watch requires periodic maintenance.Īs a watch ages the lubricants start to break down and the gears shift ever so slightly, and the accuracy of the watch will decline as well. The balance wheel needs to be adjusted to compensate for the different positions. Adjustment: This is for a watch that is fast or slow or does not have a consistent rate, especially in different positions. This procedure is probably one of the most common tasks for a watchmaker. With the appropriate time-measuring machinery a qualified watchmaker can accomplish this in a matter of minutes. This is a very simple and relatively quick procedure achieved by turning a screw. The solution would be to regulate the beat rate accordingly.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |